[. . . ] After your drivers are installed you will be prompted to repair the existing MulitPASS database. 1. Power ON your MultiPASS F30 or F50 and make sure it is connected to your computer. [. . . ] In the SysTray, right-click MultiPASS Status Monitor icon, select Close. In the 'MultiPASS Status Monitor - Closing the MultiPASS Status Monitor will prevent any status messages such as Out of Paper, Paper Jam or Communication Errors from being displayed. Are you sure you want to close the MultiPASS Status Monitor?' dialog, select Yes. Uninstall the current MultiPASS Suite by selecting Start, then Control Panel and selecting Add or Remove Programs. In the 'Add or Remove Programs' dialog, select Canon MultiPASS Suite 4. 00, then select Change/Remove. At the 'InstallShield Wizard - Repair or remove the program?' dialog, select Remove, then select Next. At the 'License Agreement' dialog, read the license agreement, select Yes. At the 'Select Printer' dialog, select F30 or F50, select Next. 6. 20. 21. At the 'MultiPASS Not Found - Setup cannot continue until the printer is connected to your computer' dialog, power ON the F30 or F50. (Found New Hardware Wizard launches. ) For USB Installation only (Parallel Installation proceed to step 26) 22. At the 'Found New Hardware Wizard' dialog, select Install from a specific location [Advanced], select Next. CHECK Include this location in the search:, type C:\temp\MultiPASS\USBDrv\Win2k\Disk1, select OK. [. . . ] (Drivers install automatically. ) At the 'Completing the Found New Hardware Wizard - The wizard has finished installing the software for: Canon MultiPASS (F30 or F50). At the 'MultiPASS Not Found - Setup cannot continue until the printer is connected to your computer' dialog, select Yes. [. . . ]